- Recent Updates
- Access Control
- Amplifier
- A/V Receiver
- Climate and Pool Control
- Disc Player / Changer
- Display
- DSP
- DVR
- Irrigation / Sprinklers
- Lighting Control
- Matrix Switch
- Media Server and Player
- Multi-Room A/V
- Power and Rack Management
- Security
- Surveillance
- Teleconferencing
- Training
- Tuner
- Utility
- Video Projector
- Voice Control
- Recent Updates
- Access Control
- Amplifier
- A/V Receiver
- Climate and Pool Control
- Disc Player / Changer
- Display
- DSP
- DVR
- Irrigation / Sprinklers
- Lighting Control
- Matrix Switch
- Media Server and Player
- Multi-Room A/V
- Power and Rack Management
- Security
- Surveillance
- Teleconferencing
- Training
- Tuner
- Utility
- Video Projector
- Voice Control
Description:
This driver is for the Vantage RFLC (formerly Enspire) wireless lighting system through the MR232-G serial interface.
Please Note: This version of the product has been replaced by the On-Q version. This driver is only here for legacy systems. Use the On-Q RFLC driver from Legrand, available here on the driver store for new, LC-7001 based, systems
Version History:
Version 1.01 adds a variable to display the ID of the last control used so you can map the system without using Hyperterminal, along with other connectivity fixes.
Version 1.02 fixes the Group variables setting the wrong range on sliders.
Vantage Enspire
XP-8 Version
Release History
1.0 The original release of the driver
1.01 New firmware better updates driver with group levels. Adds a variable you can put on a panel to tell you the ID of the last control you hit.
This driver was designed and tested with the Vantage Enspire Miro MR232 RS232 Interface using ver 0.07 and 0.08 firmware.
The driver tracks commands to the driver and uses them to update group levels. Groups aren't updated when presets are used so they won't update. Instead you can use the events generated by the presets to run an XP Macro with several Group commands .
System Variables are updated for presets and System events are triggered for each preset command.
The Group Up command sends the group to whatever it's last non-zero value was rather than all the way to the top. A second up command will send it to the top
Groups can be set to any value, and a ramp speed value is included. The ramp speed is the percentage of the ramp to happen per second. A 50 would mean to ramp 50 percent or the way per second, or a two second fade, 25 is a four second (25% per second) fade. A 100 or a 0 means to just jump instantly to the new spot. The Room and Group up commands don't have a ramp speed parameter so the variables change instantly (even though the loads don't)