Driver Type
Categories
- Recent Updates
- Access Control
- Amplifier
- A/V Receiver
- Climate and Pool Control
- Disc Player / Changer
- Display
- DSP
- DVR
- Irrigation / Sprinklers
- Lighting Control
- Matrix Switch
- Media Server and Player
- Multi-Room A/V
- Networking
- Power and Rack Management
- Security
- Surveillance
- Teleconferencing
- Training
- Tuner
- Utility
- Video Projector
Driver Type
Categories
- Recent Updates
- Access Control
- Amplifier
- A/V Receiver
- Climate and Pool Control
- Disc Player / Changer
- Display
- DSP
- DVR
- Irrigation / Sprinklers
- Lighting Control
- Matrix Switch
- Media Server and Player
- Multi-Room A/V
- Networking
- Power and Rack Management
- Security
- Surveillance
- Teleconferencing
- Training
- Tuner
- Utility
- Video Projector
This driver has been designed to provide control for the V-HOME Smart TV via IP control.
Version History
Version 1.0 (09/01/2025) - Initial Release
V-HOME Smart TV Driver Documentation
Introduction
This driver is for V-HOME Smart TV via IP control.
Connection Settings
Connection Type: IP Control
IP Address: Enter the IP address, which can be viewed in Settings -> Connection -> Network -> Network Connection -> IP Settings and check the “IP address” on TV, such as 192.168.x.xxx.
IP Port: Enter the IP port which the driver communicates with the Hisense TV. The port number must set to “11679”.
TV Setup
Step1: Make sure that the TV and Controller are connected to the same Local Area Network.
Step2: Enable the "Control Remotely" in system menu on TV: Settings -> Connection -> Device Management -> Control Remotely
Step3: When the driver trying to establish communication with the TV, the TV side will pop up a window, which shows “A Smart Device is trying to connect your TV. Do you agree to authorise it?”.
Always agree: Selecting “Always agree” will give the device permanent access permission. If not select it will give it the permission of 90 days.
OK: Clicking the “OK” button will trust the device and finish the setup.
Cancel: Clicking the “Cancel” button will not trust the device and finish the setup.
Manage your devices
Make sure the “Device Management” has shown just following the step 2 in ”TV Setup”.
Deregister Device: If click the “OK” button in step3, the device will add to Whitelist. You can check it and delete it in the “Deregister Device” of TV.
Untrusted Device: If click the “Cancel” button three times in step3, the device will be added to Blacklist. You can check it and delete it in the “Untrusted Device” of TV.
Note: One device has three chances to connect TV. After user first time decline, the reconnect timeout is 5 minutes, if Device connect again in 5 minutes, Authority will decline automatically. The reconnect timeout is 15 minutes after user decline second time. If user has declined three times, the Device will be put into Blacklist, so after this, all the reconnections will be declined by Authority Module until user removes the device from the Blacklist.
Support Function
Driver supports control commands over IP, such as: number, channel up/down, volume +/-, mute, navigation, etc.
Release Notes
Version 1.0 first release in Semtember 2025