Rollease Pulse 2 Hub

This driver is for the Rollease Pulse 2 Hub to control motors (i.e. shades) via TCP Communication.

Revision History

1.0 The Initial release of the driver

1.01 fixed a problem accessing motors 16 to 30

General Information

See Rollease Acmeda Automate Pulse Hub Operating Guide for information on setup of the system. This driver is for control and feedback only. Setup of Rollease equipment must be completed prior to setting up driver. Contact Rollease for information on how to complete setup.

Connection Settings

Network TCP is the only method for communicating with the Pulse 2 Hub. Enter the IP Address of the Hub in the TCP Address field.

Motor Count (i.e. Shade Count)

Enter the number of motors that this Pulse Hub will be controlling.

Motor Name (i.e. Shade Naming)

Enter a unique name for each motor (i.e. shade).

Motor Address (i.e. Shade Address

Enter the motor address that corresponds to the motor (i.e. shade) to be controlled. This address is acquired during setup of the Rollease system.

Driver Commands

Control commands are available for movement of motors (i.e. shades) up and down as well as adjusting the shade to a discrete level by entering a value as a percentage.

Driver Variables

Feedback variables are available for initialization state, connection state, and motor (i.e. shade) specific information including: name, address, and level.

Templates

When added to a file, the driver will look for a page template named Rollease, failing that it will use a template named Shades