Driver Details

QMotion QConnect

By: RTI
Updated: Sept. 5, 2013
Version: 1.0

Description:

This driver supports QMotion/QConnect shade controllers connected to the XP Processor via RS-232.

QMotion/QConnect

This driver is for the QMotion/QConnect series shade controls.

Revision History

1.0 The Initial release of the driver

Connection Settings

RS-232 Connection

The QConnect controller must be setup up for RS-232 operation. See QMotion/QConnect Operating Guide for more information.

The Serial (RS-232) connection on the QConnect controller should be connected to the XP processor serial adapter using the following pin out:

RTI RJ-45 -----> RJS232 -----> QConnect RJ-45

Pin 5 Pin 2 Pin 3

Pin 6 Pin 3 Pin 6

Pin 4 Pin 5 Pin 7 or 8

The QConnect controller uses a baud rate of 9600 as default for serial (RS232) communication.

Selected Channel Settings

Enable Selected Channel - Enables the Selected Channel capability in the driver for use. This feature is used for minimizing the need of setting up multiple channel pages on the user interface. The selected channel is the current channel to be controlled from the selected channel driver commands.

Last Channel ID Used

Select the last channel setup or to be accessible from the driver.

Channel Naming

Enter the names preferred for use in the driver commands, variables, and events.

Driver Notes

- Feedback variables are available for connection status, configured channel names, and selected channel only.