- Recent Updates
- Access Control
- Amplifier
- A/V Receiver
- Climate and Pool Control
- Disc Player / Changer
- Display
- DSP
- DVR
- Irrigation / Sprinklers
- Lighting Control
- Matrix Switch
- Media Server and Player
- Multi-Room A/V
- Power and Rack Management
- Security
- Surveillance
- Teleconferencing
- Training
- Tuner
- Utility
- Video Projector
- Voice Control
- Recent Updates
- Access Control
- Amplifier
- A/V Receiver
- Climate and Pool Control
- Disc Player / Changer
- Display
- DSP
- DVR
- Irrigation / Sprinklers
- Lighting Control
- Matrix Switch
- Media Server and Player
- Multi-Room A/V
- Power and Rack Management
- Security
- Surveillance
- Teleconferencing
- Training
- Tuner
- Utility
- Video Projector
- Voice Control
This driver allows for easy RTI control of the Parasound ZPre2 pre-amp, including IP control with an optional Global Cache hardware module.
Power: On/Off/Toggle
Volume: Up/Down
Mute: On/Off/Toggle
Select Input: 1/2/3/4/Next/Previous
Feedback of the current input as well as power and mute state.
Parasound Zpre2 Interface
(c) 2011 My Device.
As with most of our drivers, we support a connection via IP with the use of a Global Cache interface.
Driver Setup
Once you add the driver to your project, the following settings must be configured:
Serial Settings
Serial Port - Select the port your Zpre2 is connected to. Baud rate is fixed at 9600.
Global Cache Support:
Note: If you plan to use this outside your DMZ you need to NAT ports 4998 and 4999 to the outside world.
Enable Global Cache - Check this box if you plan to use a GC-100/iTach to remotely control the Zpre2. If you are directly connecting the XP8 to the Zpre2 leave this box unticked.
IP Address - The IP address of the Global Cache unit.
Serial Port - The port the Zpre2 is connected to on the Global Cache unit. Select serial port 1 or 2.
Licensing:
Unlock Code - Once you have purchased a license for this driver, enter the unlock code here. Without an unlock code the driver will for for 60 minutes at a time. After 60 minutes the driver will cease to function until the XP8 is reset/power cycled.
A free license is available by clicking the Get License button above and entering your processor's MAC address.