Driver Details

Klipsch KDA/Jamo JDA

By: RTI
Updated: July 13, 2018
Version: 1.0

Description:

This driver is for the Klipsch KDA-500/KDA-1000 and Jamo JDA-500 DSP Power Amplifiers using Ethernet connectivity.

Klipsch KDA-500/KDA-1000 Amplifier

This driver is for the Klipsch KDA-500/KDA-1000 Power Amplifier using Ethernet connectivity.

This driver was developed using the KDA-1000 and has not been tested on the KDA-500. As the difference between these two devices is merely the output connection, the driver should respond identically on both devices.

Revision History

The Initial release of the driver

Connection Settings

Network (UDP)

The UDP connection on the Klipsch KDA-500/KDA-1000 power amp should be connected to the Ethernet Network.

The KDA-500/KDA-1000 power amp IP address can be set to static using a terminal program or Web interface. The default IP address of the switch is 192.168.0.193.

The KDA-500/KDA-1000 power amp uses port 5000 as default for UDP (telnet) communication.

If the network connection is lost for any reason, the unit may need to be power cycled before connection can be re-established.

MTX Configuration

Zone Names

Enter the total number of zone your system will have. Enter zone (output) names preferred for use in the driver commands, variables, and events. All visible fields should be named.

Source (Input) Names

There are up to 4 unbalanced and balanced inputs available, as well as the possibility of combining the 1st & 2nd or 3rd & 4th unbalanced and balanced inputs. Enter source (input) names preferred for use in the driver commands, variables, and events. All visible fields should be named.