- Recent Updates
- Access Control
- Amplifier
- A/V Receiver
- Climate and Pool Control
- Disc Player / Changer
- Display
- DSP
- DVR
- Irrigation / Sprinklers
- Lighting Control
- Matrix Switch
- Media Server and Player
- Multi-Room A/V
- Power and Rack Management
- Security
- Surveillance
- Teleconferencing
- Training
- Tuner
- Utility
- Video Projector
- Voice Control
- Recent Updates
- Access Control
- Amplifier
- A/V Receiver
- Climate and Pool Control
- Disc Player / Changer
- Display
- DSP
- DVR
- Irrigation / Sprinklers
- Lighting Control
- Matrix Switch
- Media Server and Player
- Multi-Room A/V
- Power and Rack Management
- Security
- Surveillance
- Teleconferencing
- Training
- Tuner
- Utility
- Video Projector
- Voice Control
This driver has been designed to control of the AVProEdge AC-FRESCO-44 video wall matrix.
Version History:
Date 2025-06-18
Driver Version 1.0
Notes - Initial release
AVProEdge AC-FRESCO-44 RTI Driver
Introduction
This driver has been designed to provide control of the AVProEdge AC-FRESCO-44 video wall matrix.
Device Configuration
Configure your device as per the manufacturer's instructions. To find a copy of the user manual for your device, select your model from the manufacturer's website here:
Visit the AC-FRESCO-44 webpage and look under the configuration and check that you have the correct port for IP control. By default this port is 23
Driver Installation and Configuration
Before integrating the driver into your project it is recommended to run the demo application to test your setup and configuration.
Running Demo Program
• Open up the demo program.
• Select the processor.
• Convert the processor to the correct device if required.
• Select the drivers tab
• Select the driver.
• Configure as per the settings above.
• Download and run the application.
Adding the driver to an exsisting Program
• Open your application
• Select your processor.
• Click on the Drivers tab.
• Click Add and browser to the location your downloaded the driver to.
• Select the .rtidriver file and click open.
• Select the newly added driver and configure as per the settings above.
Driver Commands
The driver allows control of the AC-FRESCO-44 unit using a RTI touch panel or equivalent device. Commands to set the zone, source, EQ and advanced audio options are available.
The following commands are avalible:
Video Input Select
Audio Input Select
Volume step and set.
Audio mute (disable)
Balance step and set.
EQ mode selection
Audio Switching Mode
Layout Selection
Driver Variables
This driver tracks a number of variables in order to provide feedback from the AC-FRESCO-44 unit. These are as follows:
Status
Connection status
Power/standby status
Control
Video switching feedback
Audio switching feedback
Current selected layout
Volume feedback
Mute feedback
EQ mode setting
Troubleshooting
Confirm that the correct IP address is defined in the RTI config for the AC-FRESCO-44 control interface.
Confirm the port is correct as per the AC-FRESCO-44 web interface.
Ensure you can ping the AC-FRESCO-44