Atlona Technologies

This driver is for the Atlona AT-OPUS-810M, AT-OPUS-68M and AT-OPUS-46M HD matrix switchers connected via RS-232 or Ethernet. Version 1.0 was tested using an AT-OPUS-810M using AT-OPUS-RX baluns.

Revision History

1.0 The Initial release of the driver

TCP Connection

The TCP connection on the Atlona matrix switcher should be connected to the Network. It is recommended the matrix switch be set to a static IP and the port be assigned. Please refer to the Atlona documentation on how to set up the IP and port. The driver uses port 23 as a default, but this may be changed if needed.

RS-232 Connection

The RS-232 connection on the Atlona matrix switch should be connected with a straight through cable to the XP serial adapter.

The Atlona matrix switch defaults to a baud rate of 115200, but may be adjusted to 2400, 4800, 9600, 19200, 38400, 57600, or 115200. Please refer to the Atlona documentation on how to change the matrix switch RS-232 settings.

Device Model

Select the appropriate Atlona Model from the drop down. This will determine programming options.

Output and Input Naming

Enter the names preferred for use in the driver commands, variables, and events. All visible fields must be named.

Driver Notes

Commands, variables and events are available for:

Input/Output routing for audio/video together, audio only, and video only.

Input/Output naming.

System Power.

Channel Output Power

CEC Display Power (commands only)

RS-232 (commands only)

Presets