Atlona Technologies

This driver is for the Atlona AT-UHD-CLSO-824 series HD matrix switchers connected via RS-232 or Ethernet. Version 1.0 was tested using an AT-UHD-CLSO-824 with a firmware version of 1.0.00.

Revision History

1.0 The Initial release of the driver

TCP Connection

The TCP connection on the Atlona matrix switch should be connected to the Network. It is recommended the matrix switch be set to a static IP and the port be assigned. Please refer to the Atlona documentation on how to set up the IP and port.

The driver uses port 23 as a default, but this may be changed if needed.

RS-232 Connection

The RS-232 connection on the Atlona matrix switch should be connected with a straight through cable to the XP serial adapter.

The Atlona matrix switch defaults to a baud rate of 115200, but may be adjusted to 2400, 4800, 9600, 19200, 38400, 57600, or 115200. Please refer to the Atlona documentation on how to change the matrix switch RS-232 settings.

I/O Count

Select the appropriate output and input count for the switch in use. Selection is from 1-8 for inputs and 1-2 for outputs.

Output and Input Naming

Enter the names preferred for use in the driver commands, variables, and events. All visible fields must be named.

Driver Notes

- Commands, variables and events are available for input/output routing and system power

- Commands, and text variables are available for AT-UHD-CLSO-824 RS-232 output baud rates.

- Commands are available for sending ASCII and HEX strings to devices connected to the AT-UHD-CLSO-824 RS-232 outputs.