Vaddio AV Bridge 2x1 RTI Driver Instructions

This RTI driver provides IP/Telnet control of the Vaddio AV Bridge 2x1.
It supports camera power, PTZ control, PIP, source selection, mute, system power, and full feedback parsing.

Version History

Version 1.0 – November 2025
Initial release supporting full two_way control.

Features

Camera 1 & Camera 2 full power control (On / Off / Toggle)
PTZ movement with optional auto_stop logic
Zoom, Focus, and Preset recall/store
Picture_in_Picture (PIP) modes and layout control
Source switching (Camera 1 / Camera 2)
System Power & System Mute (On / Off / Toggle)
Real-time feedback parsing for power, mute, input, PIP state
Auto Stop function which can be enabled or disabled to your liking

Connection Information

Protocol: Telnet (TCP)
Port: 23
Username and Password required (configured in driver settings)

The driver handles login automatically in OnConnect().
All commands are blocked until login is confirmed.

Driver Configuration

Configure the following settings inside Integration Designer:

IP Address – IP of the Vaddio AV Bridge
Username – Telnet username
Password – Telnet password
Auto Stop – Enable or disable 300ms PTZ auto-stop mode
Camera Names – Name Camera 1 and Camera 2 for UI clarity

Device Configuration

Please ensure the device is setup as per the manufacturers install guide.
For communication please ensure that telnet is enabled
Security > Server Access > Allow CLISH Over Telnet

Supported Commands

System

System Power On / Off
System Mute On / Off / Toggle

Camera Power

Camera 1: On / Off / Toggle
Camera 2: On / Off / Toggle

PTZ Movement

Pan – Left / Right
Tilt – Up / Down
Zoom – In / Out
Focus – Near / Far
All PTZ functions support auto-stop after release
Manual Stop command also available

Presets

Recall Preset (1–16)
Store Preset (1–16)

Source Switching

Change Source → Camera 1 or Camera 2

PIP

PIP Power – On / Off
PIP Layout – All supported layouts
PIP Position – Standard presets

Feedback & Variables

The driver updates the following variables in real-time:

System

SystemPower
SystemMute

Camera 1

Cam1Power
Cam1Selected
Cam1PTZActive

Camera 2

Cam2Power
Cam2Selected
Cam2PTZActive

PIP

PipState
PipLayout

All variables include buttontag assignments for easy UI binding.

Diagnostics

All SystemVars are visible in XP Diagnostics with clear naming and categories:

System
Camera 1
Camera 2
PIP
Movement

Feedback lines (RX) and command transmissions (TX) are available via the debug wrapper using dbg().

Notes

Ensure Telnet login is enabled in the AV Bridge settings.
Commands will not send until login completes successfully.
Auto-stop PTZ requires the “Auto Stop” checkbox to be enabled in driver settings.
If changing any XML or JS files, always remove and re-add the driver in Integration Designer to refresh cached definitions.