Apex Source Proxy

This Driver allows for Source tracking within Apex.

It supports up to 64 Rooms, and up to 64 sources per room.

Using the driver is very straightforward, select the room, then select the source.

As you change sources, all other sources get deselected.

The Room Power Off command, deselects all sources in the selected room,

To use,

Add an instance of the driver to each Room.

Configure the Driver.

Add a Room Selection command to each room selection macro along with the room proxy command.

Name each source (Source 1, Source 2 etc).

Features

Power Off Popup Control

Please Wait Popup Control

Source List

Source in use List

Up to 20 Device Specific Flags that you can Set, Clear or Toggle individually or All at once.

Up to 5 Audio Output Options

If using the same sources in all rooms select the All Rooms use Source 1 Checkbox in the driver config.

This mode also gives some additional features –

You only have to configure Room 1 Sources.

Gives you Variables for whether a source is being used in ANY room.

When a source is no longer used in any room, an event is fired allowing you to run a macro to turn the source off.

If you switch between All sources the same and normal mode, you will have to redo all sources variables in the project for the driver.

V2.01

Added Source specific flags (Only available when All Rooms use Source 1 Checkbox is enabled)

There are commands to manually manipulate the Source Flags –

Select a Source flag which Clears all other Source Flags.

Set Source Flag (Only sets the selected Source Flag and doesn’t effect any other source flag).

Clear Source Flag (Same as set except that it clears the Source Flag).

Toggle Source Flag (Same as set except that it toggles the Source Flag).

Or If the Enable Automatic Source Flags option is enabled in the driver config

This feature automatically clears all other Source Flags and sets the correct Source Flag for the selected source in the selected room. Manual commands can still be used.